How To Install A Square Bathtub

If you are looking for a different bathtub, then a square bathtub may be the right choice for you! This type of bathtub is not common, but it is growing in popularity because it is unique and stylish. Bathtub installation might seem like a daunting task, but with these simple tips, you’ll have your new tub up and running in no time.
Tools and Materials Needed for installing square bathtub
When it comes to installing this bathtub, there are only a few tools and materials that you will need to get the job done. Below, we will go over what you will need to install your new bathtub.
- Drill
- Screwdriver
- Level
- Tape Measure
- Utility Knife
- Square Bathtub
- Tub Surround
- Caulk
- Screws
Now that you know what you will need, let’s go over the installation process.
Tips for installing square bathtub
Make sure you have all the necessary tools and materials. You’ll need a level, a tape measure, and a drill. You’ll also need some basic plumbing supplies. Next, mark the location of the tub on the floor and use a level to make sure it’s level. If it’s not, you’ll need to adjust the leveling feet until it is. Once it’s level, mark the locations of the holes for the drain and the overflow. Use a drill to make the holes, being careful not to damage any surrounding surfaces.
Now it’s time to install the drain. First, attach the drain flange to the bottom of the tub. Then, apply a generous amount of plumber’s putty to the underside of the drain flange. Place the drain assembly over the drain hole and screw it into place. Be sure to use a rubber gasket between the tub and the drain to create a watertight seal.
Now it’s time to install the overflow. First, attach the overflow flange to the top of the tub. Then, apply a generous amount of plumber’s putty to the underside of the overflow flange. Place the overflow assembly over the overflow hole and screw it into place. Again, be sure to use a rubber gasket between the tub and the overflow to create a watertight seal.
Finally, it’s time to connect the tub to the water supply. Use PVC pipe and fittings to connect the hot and cold water lines to the appropriate valves on the tub. Once the water lines are connected, turn on the valves and check for leaks. If there are any, simply tighten the fittings until the leaks stop. Now you’re ready to enjoy your new tub!
Tips and Tricks for installing square bathtub correctly
Here are tips and tricks to help you through the process:
- Install the tub. This is where having a friend or family member comes in handy. With one person holding the tub in place, the other can screw it into the surrounding area. Be sure to use the appropriate screws or bolts, depending on the type of tub you’re installing.
- Test the tub. Once the tub is installed, fill it up with water and check for any leaks. If everything is tight and there are no leaks, you’re good to go! Enjoy your new square bathtub.
Conclusion
We have guided you about installing a square bathtub in this post. When you follow all of the above-mentioned tips and tricks you will be able to install it correctly. Installing this bathtub can be a great way to add a unique touch to your bathroom.